Moth foiling in denmark

http://www.moth-sailing.org/Moth%20story%20ENG.wmv...

2009-01-10T15:50:00.000+01:00

http://www.moth-sailing.org/Moth%20story%20ENG.wmv

Please tell me when you have the file so i can remove it as it is very
large.

Doug

Hi Ole,Per's presentation is the best I have seen....

2009-01-09T10:20:00.000+01:00

Hi Ole,

Per's presentation is the best I have seen.

I can upload it to the IMCA site where you can download it. Send me an email and I will upload it this evening.

Doug

Super ! min adresse :Ole FreyVestergade 126440 Aug...

2009-01-08T22:30:00.000+01:00

Super !

min adresse :

Ole Frey
Vestergade 12
6440 Augusgtenborg
danmark

Hej Ole,om Du vill kan jag skica filmerna vi använ...

2009-01-08T21:57:00.000+01:00

Hej Ole,

om Du vill kan jag skica filmerna vi använde på båtmässan förra året.

Hilsen

Per ESkilson
SWE 3140

hej ole.Fedt at du er her!jeg har tumlet med samme...

2008-11-17T19:16:00.000+01:00

hej ole.
Fedt at du er her!
jeg har tumlet med samme problem med at wanden slår mod fribord. ved at flytte den ud så den løber langs stævn, samtidig mef at jeg gjorde den stivere blev det godt.
Den erfaring jeg her gjort er at der overhovedet ikke må være noget slør i systemet, samtidig med flappens forløb er meget afgørende. flappens udformning er har også meget at sige.
jeg har er ved at ændre wand på min gamle jolle, hvis du har lyst så kom op. tag skivet med, så sejler vi en tur.
Søren Horsens

Hi Ole,I am getting an delivery error from your em...

2008-11-17T08:33:00.000+01:00

Hi Ole,

I am getting an delivery error from your email - can you let me know if you have received anything or not?!

Cheers

Mike

Thanks for your comment. It sounds reasonably and ...

2008-11-16T14:56:00.000+01:00

Thanks for your comment. It sounds reasonably and I can do it that way, but this leads me to the next question: what is a normal messure for total moment of the flap messured in degrees. Why I am asking this is because I have the suspicion that I don´t have enough lift, when I intent to go for a lift off I have to sit very far back in the boat to initiate more lift. I know that there can be lots of reasons to that, one of them could be that I have had loss of efficiency in the rodsystem forinstance the becrank in the top of centerboard, which I have redone. Now it moves nicely and without any loss, the holes were to big and had to much play compared to the pins. I am now waiting for a day with nice weather to test it. (We are off season mostly with very windy conditions and cold too).

Another reason could be to much lift on the rudder but then again I don´t want to have the nose up to much when first foiling
May be I don´t realy understand when to alter the rudder angel.

Best regards Ole

It depends on your foils and the gearing on them. ...

2008-11-14T20:28:00.000+01:00

It depends on your foils and the gearing on them. Measure how much rod movement you need to get full movement of the flap. Then design your wand to give you full down lift when it points down and full up lift when lowriding. You should have the flap in the middle when the wand is about 45 degrees. However this is something to trim and tune...